Crochet Fingerless Gloves: Easy Sparkle Wrist Warmers Pattern for Beginners

Fingerless gloves are the kind of accessory you end up wearing all winter: on the morning commute, while typing at a cold desk, or when you want warm wrists but free fingers for your phone. This easy pair from Crochet Cabin adds a little extra fun with a sparkle yarn, so a simple make suddenly looks dressed up.
The pattern is quick and beginner friendly. You start with a foundation chain, work the hand in rounds with an open, lacy texture, leave a gap for the thumb and finish with a cuff at the wrist. There is no complicated shaping and no fiddly fingers, which makes it a great first wearable project or a fast handmade gift.

Images and patterns courtesy of Crochet Cabin

Crochet Fingerless Gloves at a Glance
- Designer: Crochet Cabin (YouTube: @crochetcabin6160)
- Skill level: Beginner
- Finished size: each glove is about 6 in / 15 cm long and 4 in / 10 cm wide
- Yarn used in the video: Mainstays Sparkle acrylic, medium weight (#4), in Platinum Silver
- Yarn amount: about 1.55 oz / 43 g for the finished project shown
- Hook: 4.5 mm
- Video length: about 14 minutes
What You'll Need
- Medium weight (#4) yarn, ideally one with a metallic thread for the sparkle effect
- A 4.5 mm crochet hook
- A yarn needle for weaving in the ends
- Scissors
- A stitch marker, if you like to mark the start of each round
Sparkle acrylics are soft, easy to wash and forgiving for beginners, but any smooth worsted weight yarn will do. The intro of the video also shows a pair in a dusty pink, proving the pattern looks just as good without the glitter.
Adjusting the size
The designer starts with 28 chains. To make the gloves wider or narrower, add or subtract 4 chains from that starting number. Wrap the chain around your hand below the knuckles before joining: it should meet comfortably without stretching.

How the Gloves Come Together
The video is split into short chapters, so it is easy to jump back to the step you are working on.
1. Starting the base chain (0:23 to 3:01)
Make the foundation chain and join it into a ring. This sets the width of the glove, so check the fit now rather than later.
2. Working the second round (3:01 to 4:55)
The second round establishes the lacy stitch pattern that runs up the hand. Once you see how it sits on top of the previous round, the rest of the body becomes repetitive and relaxing.
3. Completing the main body (4:55 to 6:08)
Keep repeating the pattern rounds until the glove reaches the base of your thumb.
4. Creating the thumb hole (6:08 to 6:48)
Here you leave an opening for the thumb. It only takes a minute, but it is the one step that turns a tube into a glove, so watch it closely.

5. Finishing the hand section (6:48 to 8:44)
Continue above the thumb opening until the glove covers your knuckles.
6. Securing the yarn (8:44 to 9:21)
Fasten off neatly. Sparkle yarns can be slippery, so weave your tails in a few different directions so they stay put.
7. Crocheting the cuff (9:21 to 11:58)
The cuff is added at the wrist end and gives the glove a snug, finished edge.
8. Final assembly (11:58 to the end)
The last chapter wraps everything up and shows the finished gloves being worn. Then make the second glove the same way.

Tips for Comfortable, Even Gloves
- Write down your counts. Note the number of rounds before and after the thumb hole so the second glove matches the first.
- Keep the tension relaxed. Lacy stitches need a bit of give to stretch over the hand.
- Try them on as you go. Slip the glove on after a few rounds. It is much easier to adjust early than to frog at the end.
- Lengthen to taste. Add rounds to the hand for more coverage, or extend the cuff for longer wrist warmers.
- Use good light with sparkle yarn. Metallic threads can hide stitches, so work somewhere bright.
About the Designer
Crochet Cabin, shown on YouTube as Cabana de Ganchillo, makes calm, close-up tutorials for accessories, baskets, granny squares and small gifts. The patterns are for personal use: you can make the gloves for yourself or as gifts, and if you share your work, please credit Crochet Cabin and link back to the original video tutorial.
Enjoy the Video Tutorial

Source: Crochet Cabin
Frequently Asked Questions
How long are these fingerless gloves?
Each glove in the video is about 6 inches (15 cm) long and 4 inches (10 cm) wide. You can add rounds for a longer glove.
How do I make the gloves bigger or smaller?
Change the starting chain in steps of 4. The designer begins with 28 chains, so try 32 for a wider hand or 24 for a smaller one.
Can I use yarn without sparkle?
Yes. Any medium weight (#4) yarn works with a 4.5 mm hook. The video intro shows a pair in plain pink yarn.
More from Crochet Cabin
- Quick and Easy Crochet Ear Warmer Headband for Beginners
- Crochet Braided Ear-Warmer or Headband for Beginners
- Beginner friendly! Crochet Bucket Hat

More crochet projects for you